Look under Filters and Switching Systems on
http://www.arraysolutions.com/prod_category.htm.
Jim
----- Original Message -----
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, May 25, 2005 3:53 PM
Subject: Re: [TenTec] Eliminating BCI Overload
Maybe I am tired, but I could not find the BCI filters. What are they
under?
Thanks.
----- Original Message -----
From: "Jim McDonald" <jim@n7us.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, May 26, 2005 01:21
Subject: Re: [TenTec] Eliminating BCI Overload
> I have the ICE filter because I was too cheap to buy the better one from
> W3NQN. He had two articles in QST in May and June 1998 if you want to
roll
> your own. If you want to buy a ready-made one, Array Solutions sells them
> on its web site, http://www.arraysolutions.com/.
>
> The W3NQN filters have more attenuation, especially at the high end of the
> BCB, than the ICE ones. His best one is a receive-only filter, but
> unfortunately Ten-Tecs that I own (Orion) or have owned (OMNI-VI and
Scout),
> don't have the RX antenna in-and-out loop that an FT-1000MP does, so
that's
> a project. (My PROII doesn't have one either.)
>
> Array Solutions sells the ICE ones too, and Jay, WX0B, has attenuation
> curves of both on his web site.
>
> Jim N7US
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|