Why get any at all? Don't get it on a PROIII.
John N1JM
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Thomas Jednacz
Sent: Monday, May 23, 2005 12:22 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] (no subject)
There is a critical gain setting that sets the point where distortion and
popping will occur. The setting is done at the factory but can be done by
you if you are careful and get the instructions from Paul. Simplest is to
either turn off the preamp or add attenuation to keep the signals below 35
over 9. My Orion is adjusted so I don't get the popping or distortion until
55 over 9.
73, Tom, W7QF
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of wq7x@cox.net
Sent: Friday, April 29, 2005 20:57
To: tentec@contesting.com
Subject: [TenTec] (no subject)
ORION. With signal S9+35 my new Orion
distorts audio. Is this normal with 1.372.
Thanks. Mark WQ7X
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
[This E-mail scanned for viruses by Declude Virus]
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec