Steve,
I just discovered that my Model 563 manual was missing chapter 2. I'm a new
ham - a much older and wiser ham bought the OMNI VI for me - and so many knobs
were confusing. Especially, since the microprocessor had been initialized.
I'll get a new copy of the manual from Ten-Tec [I just live down the road from
Sevierville, Tn.] and definitely take you up on your offer of help. Thanks and
73's.
John Stewart, W7HBO
Near Chattanooga, Tn.
-------------- Original message --------------
> I have a 563 right in front of me John. I would be happy to help out if you
> want to give me a phone call.
> Steve Ellington
> N4LQ@iglou.com
> ----- Original Message -----
> From:
> To:
> Sent: Sunday, April 24, 2005 10:00 AM
> Subject: [TenTec] Model 563 OMNI VI Setup Instructions
>
>
> > Have anyone developed setup instructions for the Model 563? I have an
> > OMNI VI Model 563 and can't make heads or tails of the manual. Ten-Tec
> > suggested that I contact this list and make this request. Thanks.
> >
> > John Stewart, W7HBO
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|