If you are using a TT supply, I would do exactly as the manual says.
Turn on supply, turn on rig.
----- Original Message -----
From: "Gord Hamilton" <hamie@telus.net>
To: <tentec@contesting.com>
Sent: Tuesday, April 05, 2005 01:49
Subject: [TenTec] Omni 6 step start
> Following the thread of a couple of days ago regarding a step start
> circuit for my 961 power supply, does anyone have any recomendations as
> to the value of the resistor in the step start?
>
> I would think 40 or 50 ohms for about 2 seconds would do it but am
> interested to hear your comments.
>
> Gord, ve7on
> Omni 6
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|