This senerio does not happen to my Orion.
George W2YJ
----- Original Message -----
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Friday, February 25, 2005 12:25 PM
Subject: [TenTec] Orion & Tune button
> Would some Orion owners check out this and confirm (or refute) what I see?
>
> I understand the operation of the TUNE button is that when you push it,
> the
> Orion puts out approximately 40w for tuning. You push the TUNE button
> again
> to turn it off (this is without the internal tuner, which I don't have).
> However, if you push the PWR button while in tune mode, the Orion will
> change to the output level set by the PWR value.
>
> Try this, set the PWR at 80 to 100 (full power). Hit the TUNE button. The
> Orion shows about 40 watts out. Hit the PWR button and the indicated power
> jumpt up. Hit the TUNE button to stop the tuning. Now, hit the TUNE
> button
> to start the tune process again. On my Orion, the meter indicates the
> higher
> power level and then drops back to the 40 watt level. However, this may
> just be the meter as an external meter indicates that the power output is
> constant at the 40 watt level. This is when transmitting into a dummy
> load.
>
> 73,
> Mark
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|