--- Barry N1EU <n1eu@yahoo.com> wrote:
>
> Why not connect your Beverage through a wattmeter to
> a
> dummy load and measure the power dissipated while
> your
> transmitting at full power into your transmit
> antenna.
> You could then calculate the voltage and know
> whether
> you're front-end is even seeing dangerous levels at
> all.
>
You might need to put a voltmeter across the dummy
load if your wattmeter can't read low power levels.
__________________________________
Do you Yahoo!?
Meet the all-new My Yahoo! - Try it today!
http://my.yahoo.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|