I use a Rigblaster and Rigblaster supplied cable for TT and successfully
used all digi-modes on Scout.
I am sure the connections are same protocol as the Rigblaster: connect cable
to mike connector on radio to mike connector on MFJ; connect audio out from
radio to computer sound card, "in". connect audio out from sound card to
audio in on the MFJ.
The serial cable connects between MFJ and computer; adjust audio sliders on
software til the ALC just flickers;
Ron
Wb1hga
George writes:
I have a scout and an MFJ1273bt interface with four pin mike and am using a
new Dell 3000 using microsoft 'xp' and digipan xx absolutely no luck
getting out. Has any one else been able to do this or does anyone have an
answer to the problem. all help welcome.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|