TenTec
[Top] [All Lists]

Re: [TenTec] Re: Orion: going back zu 1.371, read why

To: <tentec@contesting.com>
Subject: Re: [TenTec] Re: Orion: going back zu 1.371, read why
From: "George" <w2yj@highstream.net>
Reply-to: George <w2yj@highstream.net>, tentec@contesting.com
Date: Mon, 20 Dec 2004 09:30:27 -0500
List-post: <mailto:tentec@contesting.com>
I use to get intermittent loss of either receiver. I thought it was the Orion. Turns out to be my computer when it boots up!!
I have the Orion hooked into my COM port to run RTTY and PSK31. It took me a while to associate the booting with loss of RX?????
Just my 2 cents.
George
----- Original Message ----- From: "Robert Carroll " <rlcarroll@patmedia.net>
To: <tentec@contesting.com>; <DK2GZ@aol.com>
Sent: Sunday, December 19, 2004 5:35 PM
Subject: RE: [TenTec] Re: Orion: going back zu 1.371, read why



I can't comment on the keyer issue, but I have all the other
problems--including the audio pops--which are an annoyance but not like the
loss of either receiver--which I also get fairly frequently--but I had about
the same problem with this on the previous firmware. I abe also doen all
the resets and ram clears.


Bob W2WG

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Gary Tuck
Sent: Sunday, December 19, 2004 5:08 PM
To: DK2GZ@aol.com
Cc: Ten Tec Mailing List
Subject: [TenTec] Re: Orion: going back zu 1.371, read why

I agree with your post Harry.  I also would like to return as well, but
my Orion came with 1.371 and they've taken it off the server it
appears. So, I've written ditsnbits to see where they have it
available.  I also operate CW almost exclusively.

I've lost my main receiver twice and sub receiver once in the last two
days.  The keying loop issue remains so occasionally I lose my ability
to transmit as well.  I don't believe the NR works as well and I've
little pops when I turn the AF control.  They got the keyer Mode
backwards--if you choose Mode A and restart, the menu will read mode A
but it actually is mode B like it was in 1.371 and before.  The same
squeezing in Mode B which gives you a "C" will return a "K" in mode A.

good luck, Gary W7TEA

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>