Yup, every time I light up on the Omni-D barefoot on 40m I smoke the GFI in
the back room. That'd be on a coil loaded vertical. GFI's don't like RF
much at all, even a fluorescent light popping on and off will snap them.
Hope we can find a solution, I tend to blow these alot
73 de KC0NPF
----- Original Message -----
From: "Charles Greene" <w1cg@qsl.net>
To: <tentec@contesting.com>
Sent: Tuesday, December 14, 2004 03:34
Subject: [TenTec] GFI Problems
> Hi,
>
> I hooked up my Swan Linear to my OMNI-VI and had some RF in the shack when
> using my Windom antenna which I cured by installing a couple of 1:1 baluns
> in the coax feed line, but I still have one problem I haven't solved
> yet. When I transmit, the upstairs bathroom Ground Fault Isolator trips,
> probably on RF. The antenna is about 15 ft from the GFI, so the wires
> going to the GFI may be picking up the RF directly from the antenna. On
my
> vertical which is about 30 ft from the GFI, there are no RF problems. Has
> anyone had this problem, and what did you do to eliminate it? I must be
> somewhat common because I was talking to a local ham who had and still has
> the same problem. I was thinking about installing some .001 ufd caps
> across the wires in the bathroom wall coming into the GFI receptacle. I
> don't know if that would do the job or make it worse.
>
> TNX for the bandwidth
>
> Chas, W1CG
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|