Sounds like the TxE (Etc) shunt is loose, try reseating it...
dave W7DPW
----- Original Message -----
From: "Scott Walker" <N3SW@worldnet.att.net>
To: <tentec@contesting.com>
Sent: Saturday, December 11, 2004 1:25 PM
Subject: [TenTec] Omni VI Opt. 3 Stopped Transmitting
> The radio stopped keying right in the middle of a CW traffic net
last night.
> Sidetone works. Receiver is fine. I got no power output on any
band in any
> mode.
> I tried it again after a night's rest, and at first it worked. Then
after
> about ten minutes, same deal, no transmit. I did a partial reset of
the
> processor without improvement. Then I did a full reset without
improvement.
> As of now, it won't transmit in any mode regardless of how long I
rest it.
> I plan to call TenTec on Monday for suggestions. I thought I would
ask for
> ideas on here as well.
> Thanks in advance for any pointers.
> -Scott N3SW
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|