[TenTec] Noise

[Ron Feutz <feutz@wctc.net>]

TT'ers,

I have some ugly new noise at the QTH.  Starts out low and quickly builds 
to S 5-6 (RF gain up, 500 hz filter) for 10-20 seconds, and then abruptly 
stops.  It seems to cycle about once a minute.   The Omni 6+ NB does a good 
job on it, but when a strong adjacent signal starts up (within 10 Khz or 
so), I hear the guy's CW as raspy noise in my passband, and its strong 
enough to wipe out  weak sigs.  The occurs when the noise is strong.  When 
the noise is absent, I don't hear the garf from strong adjacent sigs.

Any idea on what  this type of noise is?  If its from a power line or 
transformer, would it cycle like that?(I'm going fox hunting with a 
portable AM radio tonight).

What causes me to hear the raspy CW when the noise is there, but not when 
it isn't, and is there anything I can do about that?

73,

Ron - WA9IRV


  


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec