To: | <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] Omni VI Opt. 3 Stopped Transmitting |
From: | "Tommy" <aldermant@alltel.net> |
Reply-to: | tentec@contesting.com |
Date: | Sat, 11 Dec 2004 17:25:16 -0500 |
List-post: | <mailto:tentec@contesting.com> |
Also see if it will transmit when you push the TUNE button. If it
does, do the obvious and check your keying line. If it does not, see
if you are drawing any current when you push the tune button. If it
draws no current, it may be bad news, like final transistors. Good
luck ! Tom - W4BQF ----- Original Message ----- From: "Alan Zaur" <AlanZaur@Adelphia.Net> To: <tentec@contesting.com> Sent: Saturday, December 11, 2004 4:42 PM Subject: Re: [TenTec] Omni VI Opt. 3 Stopped Transmitting Scott:
|
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TenTec] Heil Ten-Tec Studio One on Argonaut?, Michael B. Blake |
---|---|
Next by Date: | [TenTec] FS: [Ten-Tec] Station & accessories, Bob Janney |
Previous by Thread: | Re: [TenTec] Omni VI Opt. 3 Stopped Transmitting, Alan Zaur |
Next by Thread: | Re: [TenTec] Omni VI Opt. 3 Stopped Transmitting, Dave W7DPW |
Indexes: | [Date] [Thread] [Top] [All Lists] |