Same place. Mine was a yellow wire loop labeled HAM and its about 1/3 from
the back of the radio on the right side. Not sure what the board is, but it
works well.
73 Rick
N4ASX
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Jim Bull
Sent: Wednesday, December 08, 2004 9:34 AM
To: tentec@contesting.com
Subject: Re: [TenTec] OUT OF HAM BAND MODIFICATION
Bob,
On my two Paragon's, the MARS/CAP/60M mod is accomplished by
cutting/unsoldering the jumper wire on the logic board (Labeled "HAM")
and resetting the processor. The jumper is located directly below the
9 volt memory battery.
NOW, if someone can tell me what/where the mod is on the Paragon II,
I would appreciate it VERY much.
Jim/Ke3nK
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Robert Lutz wrote:
> Does anyone have the modification to make the Paragon transmit out of
> band
>
> tnx 73 Bob
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|