Re: [TenTec] Re: New Orion Update

["A. Sewell" <n5na@att.net>]

Me three.  Right after loading 1.372 I rotated the BW control and 
completely lost audio.  I had to turn the rig off and back on to recover 
it.  I then did the memory clear routine and a master reset.  I haven't 
completely lost the audio again but have noticed the "spot" effect noted 
by Bob below.

Another time I turned the rig on and there was no audio at all.  I 
turned the rig off and back on and all was well.  Haven't seen that one 
again either.

73,

Alan  N5NA


Robert Carroll wrote:

> I have seen this too.  When rotating the BW control it almost sounds like
> the effect of rotating a volume control with a bad spot in it.  Get past the
> "spot" and all is ok.  Go back in the other direction and hear the audio go
> dead--past it and all is ok.  This was occasionally the case and not
> reproducible, and I don't know if it occurred at the roofing filter switch
> points.  It was not present with the earlier firmware version.  But I can
> work around it, and on balance I still think this version is a nice
> improvement.
>
> Does anyone know whether the programmers are getting near the maximum
> allowable lines of code?
>
> Bob W2WG
>
>
>  
>
>  
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec