Sergie,
I will reply to your question by describing a situation occurring at a
friend's QTH (he doesn't monitor this board).
He is experiencing the ARC FAULT on his 2000A, but only on 20m and when
running his beam (which is quite far from the shack). If he runs a dummy
load or his vertical, he does not experience this problem.
The firmware is 1.371.
He wanted to upgrade to 1.372 over the weekend but I haven't heard from him
yet.
I will visit him soon and perform the modification to his linear.
I will let you guys know if it helps.
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Sergei Kulyov
Sent: Friday, December 03, 2004 1:24 PM
To: tentec@contesting.com; Orion@contesting.com
Subject: [TenTec] Firmware upgrade and CW/ACOM2000A issue again
Does anybody got an issue while in CW keying ACOM2000 after
upgrade to 1.372? My ACOM immediatly fails to transmitt
with "ARC fault" alarm althouth I'm using it in QSK mode.
Missing super condx on 160..
73! Sergei UA3AP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|