Yes. After loading 1.372 and doing a master reset, etc - the internal keyer
timing is a problem for me as well. I use the Orion almost exclusivly for
cw (up to 35WPM.) For now, I'm planning to switch back to an external keyer
as I'm delighted with the QSK and other improvements in this update.
FWIW I can also confirm the development of popping noises in the right
channel of headsets I'm using.
Jack, KC3M
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Gary Tuck
Sent: Friday, December 03, 2004 11:07 AM
To: Ten Tec Mailing List
Subject: [TenTec] Firmware upgrade and Keyer timing
Is anyone else been having problems with keyer timing after the
upgrade? I see the new choice in the CW menu and have chosen Mode B
which is what I think I learned with my old Heath keyer, and I assume
what was built into the 1.371 and before. But now, my "K" becomes an
"M" half the time and my "R" becomes an "A". I trudge along at about
22 wpm, but had no problems of this nature sending prior to 1.372. If
I choose Mode A, I have the same problem so wondering if it's stuck in
Mode A??
After install, I did a Ram-clear and answered all questions Yes and
also a master reset. All other functions seem to be working OK. I had
read somewhere on the List that one should uncheck the box about
"stopping on error" which I did----so the program could not verify the
installation. Is it possible that this could be the source of the
problem?
tnx, Gary
_______________________________________________
TenTec mailing list
TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|