I notice the click in the right headphone pad when using panoramic mode on
the main receiver. I don't hear it with main selected for both earpads.
Bob W2WG
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of DK2GZ@aol.com
Sent: Friday, December 03, 2004 12:28 PM
To: tentec@contesting.com
Subject: [TenTec] Firmware upgrade: click in headphone and Keyer timing
Hello TT-Group
I just installed the 1.372 firmware.
Two things i noticed in difference to 1.371:
1. Click in headphone
Using headphones and listen only the main RX, there is a click in right
headphone pad.
If I mute the main RX and listen only to the Sub-RX there is no click
present.
2. Keyer timing
I also see no difference in Mode A and B.
Also still cant use the internal keyer because of the timing, stick still
with the external IDOM-Press-Keyer
No solution also with the new firmware:
Preamp or ATT not stored per band. If you using the preamp on the highbands
and going back to the low bands you have to switch the preamp off manual.
Even my K2 and TS570 can this remember per band!
If you are set the PBT +- for RTTY operation and switch back to CW you
have
clear
the PBT setting manual.
73 de Harry, DK2GZ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|