Is anyone else been having problems with keyer timing after the
upgrade? I see the new choice in the CW menu and have chosen Mode B
which is what I think I learned with my old Heath keyer, and I assume
what was built into the 1.371 and before. But now, my "K" becomes an
"M" half the time and my "R" becomes an "A". I trudge along at about
22 wpm, but had no problems of this nature sending prior to 1.372. If
I choose Mode A, I have the same problem so wondering if it's stuck in
Mode A??
After install, I did a Ram-clear and answered all questions Yes and
also a master reset. All other functions seem to be working OK. I had
read somewhere on the List that one should uncheck the box about
"stopping on error" which I did----so the program could not verify the
installation. Is it possible that this could be the source of the
problem?
tnx, Gary
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|