Re: [TenTec] Orion and digital modes?

["Dennis Bryant" <brya5984@bellsouth.net>]

Thanks for this information. I tried to use my Orion on PSK31 for several 
weeks and never could get the right hook-up. I called TT about my problems 
and they tried to help, but they seemed not to have a good handle on this 
either. The manuel was no help although the old manuel was more help than 
the new manuel. I finally gave up, but maybe I will try once again. I could 
not get the radio to transmit. I think the stereo to mono adapter may help.

Dennis N4MUS
----- Original Message ----- 
From: <K4IA@aol.com>
To: <tentec@contesting.com>
Sent: Sunday, November 21, 2004 8:52 AM
Subject: Re: [TenTec] Orion and digital modes?


> The interfaces are nothing more than isolation transformers.  You may or 
> may
> not need one depending on grounding, hum, or RF in the shack issues.  I 
> use
> one from Donners Digital and it works great.  I ordered the Microham 
> version
> because it adds USB to Serial control of the radio and CW.  Has been 
> shipped but
> hasn't arrived.
>
> Here's a few tips that are not interface related but may help you in your
> setup.
>
> Remember to set Menu => SSB => Audio source to AUX to use the input from 
> the
> AUX jack.  If you set it to MIC, nothing from the Aux jack goes to the 
> audio
> input and if you set it to BOTH, your Mic is "live."  Use the same SSB 
> menu to
> adjust your AUX Input Gain to a level that is comfortable with your sound 
> card
> settings.
>
> Since the output from the Orion aux jack and supplied cable is at a fixed
> level on left audio, you have to be sure you watch your AUDIO => Left 
> setting.
> If it is on "Both" you will get audio from both Rcvrs feeding into your
> soundcard.  Since the output is fixed, just turning down the volume on the 
> Sub RX
> does not change the level coming out the aux jack.  I had a terrible time 
> with a
> double trace appearing in PSK31.  Turns out I had the Sub Rx on with one 
> VFO
> set to USB and the other to LSB so both signals were showing up on my 
> screen
> but slightly offset.
>
> One final note, the output of your computer is stereo but the input to the
> radio is mono.  The output of your software may also be mono.  Thus, if 
> the
> computer software output is on one channel but the radio input is on the 
> other,
> the sound doesn't get from your computer to the radio.  It drove me crazy. 
> I
> finally got a stereo to mono adapter plug and plugged the radio input into 
> one
> side and then the other until I found the correct side for the audio.
>
>
> Radio k4ia
> "Buck"
> Fredericksburg, Virginia USA
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec