[TenTec] RE: OMNI VI+ clock not working

[<dbp@tds.net>]

 Thanks for the suggestions about my clock problem. 
 I did finally call Ten Tec. It was suggested to put a 'scope across the clock 
XTYL to see if it was working. Yup. Another look at the schematic showed a 
variable cap. across the XTYL for fine tuning the time. After checking out the 
adjusting slot orientation- one short turn to exercise it- then back to where 
it had been set and it started right up. 
 73 de Dave in NH