Martin: I had the same problem with my Orion. They sent me the K2 cable
and it just wouldn't work. After a couple of conversations with Jim at
SteppIR, we decided that the pin connections were incorrect. They sent me
another cable, but I built one in the meanwhile.
The correct pin to pin connections are Pin 2 to Pin2, Pin5 to Pin5, Pin3
to Pin3, and Pin7 to Pin7? Pin 7 and Pin 9 must be jumpered at the SteppIR
Controller end. This worked for me and the cable that I later received also
worked.
I think if you make up a cable with these pin outs you will get the
interface to work.
73,
Bernard, WA4OEJ
----- Original Message -----
From: "Martin Ewing" <martin@aa6e.net>
To: <tentec@contesting.com>
Sent: Tuesday, August 24, 2004 8:28 PM
Subject: [TenTec] Steppir vs Orion
> Just got my SteppIR up yesterday. All is well, except...
>
> Hooked the Orion serial port to the Steppir data in using
> Steppir-supplied "K2" cable. Set everything up according to manual, I
> think. No communication, despite power cycling, master reset, etc.
>
> This is with firmware 1.371.
>
> There was a lot of discussion a few months back about Orion/steppir.
> One may be forgiven for naively thinking it should work out of the box
> for current production.
>
> Anyone know the scoop? TIA
>
> 73, Martin, AA6E
> pics at www.aa6e.net/aa6e
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|