TenTec
[Top] [All Lists]

Re: [TenTec] OMNI D type C help

To: tentec@contesting.com
Subject: Re: [TenTec] OMNI D type C help
From: w8au@sssnet.com
Reply-to: tentec@contesting.com
Date: Wed, 18 Aug 2004 13:10:37 -0400
List-post: <mailto:tentec@contesting.com>
At 01:04 PM 08/18/2004, you wrote:
those radios can go into oscillation if their ALC circuit is not working properly.
The ALC voltage is generated by diodes which are on the same board as the
SWR diodes. If working there, replace them all.

To add to Mike's excellent advise, you might also change out all the small electrolytic bypass caps you find on the final AMP pc board.

When these dry up, instability begins...

(after all, the age of this rig is close to 25 years)

Perry w8au

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>