In a message dated 8/15/2004 9:21:28 AM Eastern Daylight Time,
btippett@alum.mit.edu writes:
However, with the Filter selection set to AUTO, the visual indicator - that
little line above the filter bandwidth display still shortens at 360hz as if
the 500hz filter is cutting in. It also shortens again at 190hz as if the
250 filter was in although I have never owned one and neither is activated
in
the menu. If a specific filter is selected, the line shortens to match
that
filter even if one is not installed.
Which firmware version are you using?
Thanks for the info. I am using 1.371. I reloaded it and did a Master
Reset but the visual indicator still tracks the "imaginary" filter.
I can hear the difference as the real roofing filters kick in so I am going
to assume everything is working OK except for the indicator and await a
magical fix in a future firmware release.
Radio k4ia
"Buck"
Fredericksburg, Virginia USA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|