See Ten-Tec archives; the solution for this was posted Thursday, Jan. 22,
2004.
Good luck,
Jim Miller, K4SQR
http://www.comteksystems.com
4-Square Experts, Stack Yagi
& Remote Antenna Switching Systems
On Sat, 24 Jan 2004 13:21:42 -0500 "K. Indart" <kitdart@ntelos.net>
writes:
> Hi Don,
> I have the problem on my Omni VI Option 3, that the CW speed tends
> to vary
> somewhat.
> I seem to remember seeing that a solution was to place a ceramic
> capacitor across the leads on the SPEED CONTROL. Don't remember the
> value
> but guess a .01 or .001 I suppose it is some RF getting into the
> speed
> control.
>
> If you have some concrete information I would surely appreciate it,
> as it is
> kinda annoying problem. CW since late 40's.
>
> Best 73, Ken WA4RPH (kitdart@ntelos.net)
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On
> Behalf Of Don Rasmussen
> Sent: Thursday, January 22, 2004 1:27 PM
> To: tentec@contesting.com
> Subject: [TenTec] OMNI VI+ Question
>
> Hi Guys,
>
> I saw a bitmap image of an OMNI 6+ mod that was
> supposed to eliminate the internal keyer from speeding
> up or slowing down at the WPM boundry. It was a
> capacitor pressed into a push-on connector. Does
> anyone have this or know where I can get it?
>
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! SiteBuilder - Free web site building tool. Try it!
> http://webhosting.yahoo.com/ps/sb/
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|