Yikes!!! A poison tube???
Spewing out toxic RF??
Actually, it was the heat sink conduit...a Beryllium block that is toxic if
shaved, sanded, or otherwise "messed" with.
The HA14 (Compact Kilowatt) is an SB200 with an external power supply. It is
small!!
Also quiet because of no fan. The difference between the HA14 and the SB230
is that the 230
had a quiet system of cooling. The HA14 had no cooling. It gets pretty hot,
and should have a 8 or 9 watt fan on top of it. The HA14's filaments are in
series vs parallel for the SB200.
Both amps work great. I wish the idea behind the SB230 could have been
pursued. I don't think it is impossible to have silent operating amps.
...Dave
----- Original Message -----
From: "Rick Westerman" <Rick@dj0ip.de>
To: <tentec@contesting.com>
Sent: Tuesday, January 20, 2004 12:46 AM
Subject: RE: [TenTec] Quieting fan
> It was the 70's and the mobile amp was (as I recall) the HA-14
> using 2x 572B's.
>
> The problem with the SB230, apart from the tube being highly
> poisenous, is simply the cost of a new tube and the extreme
> difficulty of locating one anyway. Otherewise it was a good amp.
>
> 73
> Rick
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Ron Notarius
> WN3VAW
> Sent: Tuesday, January 20, 2004 5:28 AM
> To: tentec@contesting.com
> Subject: Re: [TenTec] Quieting fan
>
>
> Wasnt the SB-230 the allegedly mobile linear, or am I thinking of
> a
> different one? Also, I seem to recall it from the era of the
> late 60's
> and/or '70's, not the '80's.
>
> 73, ron wn3vaw
>
> "I'd give real money if he'd just shut up!"
> Dr. Leonard McCoy, "Start Trek VI: The Hills Are Alive with the
> Sounds of
> Klingons"
>
> ----- Original Message -----
> From: "Dave Edwards" <kd2e@comcast.net>
> To: <tentec@contesting.com>
> Sent: Monday, January 19, 2004 11:01 PM
> Subject: Re: [TenTec] Quieting fan
>
>
> Steve... My 1KW Heathkit SB230 from ...I guess the early '80s
> uses a heat
> sink cooled tube.
> A single 8873, it uses no fan...just a heat sink on the back and
> does an
> easy 600 watts out.
> Totally quiet!!
> ...Dave
> ----- Original Message -----
> From: "Steve Weber" <kd9bo@mac.com>
> To: <tentec@contesting.com>
> Sent: Monday, January 19, 2004 8:17 PM
> Subject: Re: [TenTec] Quieting fan
>
>
> > Dear fellow cult-of-the-cosmic-orange-dot members,
> >
> > Would it be possible to surround the tube with a finned heat
> sink
> > similar to those used on some transistors? What about ducting
> that
> > discharges by the tubes or even surrounds the tubes? Having
> never
> > seen the inside of this amp, I may be simply blowing hot air.
> (ouch)
> >
> > KD9BO Steve
> >
> > >Hi Gary,
> > >
> > >The original post was in regards to an amplifier which uses a
> pair
> > >(maybe 4) 572B triodes. These are glass envelope tubes. While
> it may
> > >be possible to precool the air using a chilled water system,
> there
> > >would still be a need for a fan to blow the air across the
> tube
> > >envelopes. Perhaps the air flow rate could be reduced and the
> fan
> > >could be quieter using cooler air.
> > >
> > >There are water cooled tubes and conduction cooled tubes,
> which
> > >could reasonably incorporate a liquid heat transfer media. In
> the
> > >case of glass envelope tubes I really see no reasonable way
> that
> > >water cooling could be applied.
> > >
> > >DE N6KB
> > >
> > >
> > >
> > >
> > >_______________________________________________
> > >TenTec mailing list
> > >TenTec@contesting.com
> > >http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> > --
> > Steve Weber
> >
> >
> > No trees were killed in the sending of this message. However
> > a large number of electrons were terribly inconvenienced.
> >
> > *******************************
> >
> > Hey spammers - Harvesting email addresses? Don't overlook these
> guys!
> >
> > FCC Chairman Michael K. Powell: mpowell@fcc.gov
> > FCC Commissioner Kathleen Q. Abernathy: kabernat@fcc.gov
> > FCC Commissioner Michael J. Copps: mcopps@fcc.gov
> > FCC Commissioner Kevin J. Martin: kjmweb@fcc.gov
> > FCC Commissioner Jonathan S. Adelstein: jadelste@fcc.gov
> >
> > US Postal Service: customer@email.usps.gov
> > Fraud Watch: fraudinfo@psinet.com
> > Federal Trade Commission: consumerline@ftc.gov
> > Federal Trade Commission: uce@ftc.gov
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|