How are you measuring power ?
----- Original Message -----
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, January 06, 2004 22:03
Subject: [TenTec] Omni V Output???
> Could anyone on the list tell me what the normal output of an OMNI V be?
> Mine has the QRP mod and with full counterclockwise of the internal ALC
> adjustment pot I get the following output.
> 10 Meters 85W
> 15 Meters 90W
> 20 Meters 90W
> 40 meters 95W
> 80 Meters 100W
> Is this typical real world output for the OMNI V into a 50 Ohm dummy load?
> The QRP modification was done to this rig by previous owner.
> If I replace the 10k R46 on the 9 Mhz Filter Circuit Board with the
original
> 100k I know I will get more power output on the low but will it restore
the
> output on the top end?
> Right now with the mod I can go down to 5 watts with the drive control
full
> counterclockwise.
> Factory says should be 25W at that setting.
> Don't want to go through to replace R46 if it will not cause a change on
the
> top end.
> Thanks,
> Dan N4VET
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|