Re: [TenTec] OMNI VI & 1210 2M Transverter

[Dennis Ashworth <K7FL@ARRL.NET>]

Thanks Guys ... I'd like to make the solution somewhat immune to operator 
error, so turning the power down (albeit a workable solution) probably 
won't meet the needs - I'm leaning towards building a resistive pad unless 
someone has devised a solution where the power can be reduced internally 
without intense modifications.

Thanks
Dennis, K7FL

===========

   At 06:13 PM 1/2/2004, you wrote:
> What about just turning the front panel power output control all the way
> down? That's what the 1210 was designed for.  Or are you concerned that
> you'll forget and blow up the 1210?  That would be my luck.
>
> Mark
>
> ----- Original Message -----
> From: "Dennis Ashworth" <K7FL@ARRL.NET>
> To: <tentec@contesting.com>
> Sent: Friday, January 02, 2004 8:48 PM
> Subject: [TenTec] OMNI VI & 1210 2M Transverter
>
>
> > Santa brought me a TenTec 1210 Transverter kit for use with my OMNI VI+.
> > Any fellow OMNI VI users know how to reliably reduce the Omni power to the
> > 20 watt, 10M input requirements of the transverter? I can certainly build
> a
> > resistive pad, but I suspect there might be a more "elegant" solution
> > available.
> >
> > Thanks,
> > Dennis, K7FL
> > Battle Ground, WA
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec