With firmware version 1.367, you can send CW with the Orion by simply
sending characters to the Orion via the comport. My Orion control software
uses this function to run a CW keyboard.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Barry N1EU" <n1eu@yahoo.com>
To: <tentec@contesting.com>
Sent: Sunday, December 28, 2003 1:41 PM
Subject: [TenTec] Orion PTT question (seriously)
> I understand that you can't control cw transmit via
> external PTT line on the Orion. But does the Orion
> support PTT control via software command on the comm
> port? I know WriteLog and N1MM Logger both support
> this mode, and that's what I normally use on my
> unOrion: no break-in, vox or external PTT line needed
> for the computer-generated cw.
>
> Thanks & HNY 2K4,
> Barry N1EU
>
> P.S. AGN, if you're reading this, you had a seriously
> loud signal last night Bob - tnx SP Q
>
> __________________________________
> Do you Yahoo!?
> New Yahoo! Photos - easier uploading and sharing.
> http://photos.yahoo.com/
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|