Re: [TenTec] MixW and use with Orion and Argonaut V

["Tom Azlin, N4ZPT" <tom@n4zpt.org>]

Hi Carl,

Yes, go into the Configure menu then select TRCVR CAT/PTT then select which 
radio.  Then click on Details and sellect port, data rate, etc.  Set RTS to 
always on, DTR to what you want.  Just did it here.
73, Tom n4zpt

On Wed, 30 Jul 2003 11:05:43 -0400, N4PY <n4py@qvssoftware.com> wrote:

> The argonaut V runs at 1200 baud.  The Jupiter and Orion run at 57600 
> baud.
> Is there a way to change the baud rate in MixW?  In other words, can you
> configure MixW for a Jupiter and also set the baud rate to 1200?
>
> Carl Moreschi N4PY
>
> ----- Original Message -----
> From: <duffyb01@fuse.net>
> To: <tentec@contesting.com>
> Sent: Wednesday, July 30, 2003 10:41 AM
> Subject: [TenTec] MixW and use with Orion and Argonaut V
>
>
> > I sent Nick an email about enhancing MixW to control the Orion and the
> Argonaut V.  I also sent him files related to the PC control of the Orion
> and the Argo.  This is what Nick said:
> > >>>Hello Duffy,
> >
> > Please try "Jupiter (enhanced PC control) with
> > Argonaut - V and ORION
> >
> > The documentation says that Jupiter, ORION and Argonaut have same 
> > commands
> > for frequency and mode control.
> >
> > Please let me know the result.<<<
> >
> > O.K., so I tried it as suggested with the Argonaut V and simply cannot 
> > get
> it to work.  I have used the same settings that I use with my Jupiter and
> MixW is simply unable to control the Argo.  Can anyone else give this a
> shot?  Does anyone else have any suggestions as to why it is not working?
> The N4PY software works perfect with the Argo, but cannot get the same
> result with MixW.
> > Anyone up to the challenge?
> >
> > Regards,
> >
> > Duffy
> > www.wb8nut.com
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


--
Tom Azlin, N4ZPT