Have you checked to see if the correct transmit filter
has been switched in on the other bands? Also check
the receiver bandpass filters. A shorted pin diode
could cause low drive in transmit because the wrong
bandpass filter is in the circuit at all times. This
happened to my Pegasus.
73, Dave VE1ADH
--- Rick Williams <rick.williams@telus.net> wrote: >
After my success this afternoon I had an enjoyable
> dinner and returned to
> the rig!
>
> The problem is back. All bands except 80 metres
> have low output. The
> voltage drop (under load) across the fuse is
> approximately 0.1 to 0.2 volts.
> I'd think that is fairly typical.
>
> Anyway - it's back to the drawing board.
>
> 73,
>
> Rick
> VE7ASR
>
> Web site: http://www3.telus.net/ve7asr
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
______________________________________________________________________
Post your free ad now! http://personals.yahoo.ca
|