Keith,
You need to configure in LOGGER the folder that my n4py program is installed
in. "c:\n4py" is the default but you could have specified another one.
Also, make sure logger is using the ten-tec file interface and not the n4py
file interface. I know LOGGER can use either one.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Keith Lodahl" <lodahlkh@charter.net>
To: <tentec@contesting.com>
Sent: Tuesday, March 04, 2003 9:06 PM
Subject: [TenTec] Info on connecting W4PY and Logger
> I was following a thread on this topic, downloaded Logger, and missed the
> last message(s) about how to get the programs to talk with one another. I
> am using Carl's W4PY and wish to control the radio with this software. I
> found the box to configure Logger to work with W4PY and checked the box.
> How do I pull time and frequency into Logger? What else do I have to
> configure in Logger to get it talking to Carl's program. I am assuming I
> don't have to go through a comm port, but since it isn't working then that
> may be wrong. HELP!
>
> Keith Lodahl
> KB9NUM NNN0ACS
> President, Rock River Radio Club
> ARRL Official Emergency Station
> ARRL Public Information Officer
> ARRL Volunteer Examiner
> 920-387-4675
> kb9num@charter.net
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|