I've written Carl directly but wonder if there is anyone on this list who
knows the default baud-rate of the Omni-V after this chip is installed?
I need the actual baud rate... saying "It's the same as the factory
baud-rate" would make me laugh but wouldn't help much 8-)
Tom K2TA
Greenwood Lake, NY
----- Original Message -----
From: "Carl Moreschi" <n4py@earthlink.net>
To: <tentec@contesting.com>
Sent: Saturday, February 22, 2003 11:07 AM
Subject: [TenTec] Omni V.9 Upgrade Chip
> I have seen several people recently having difficulty getting the
> microprocessor chip from Newark Electronics for my Omni V.9 upgrade,
> especially people in Europe. I have decided to make it a lot easier for
> people to do this upgrade. I have purchased several of the chips myself
and
> have them all programmed and ready to go. By me purchasing the chips in
> bulk, it is actually cheaper for people to get the chips directly through
> me. I am selling these chips for $20 a piece including shipping and
> handling charges. This is a zero profit service that I am providing for
> people that want to upgrade their Omni V to get greatly enhanced function.
> If you are interested in upgrading your Omni V, send me an email at
> n4py@earthlink.net for full details.
>
> Carl Moreschi N4PY
> Franklinton, NC
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|