When I did the A/B test with a couple of rigs a few years back, I used a T
connector and then had both rigs on at the same time, on the same antenna. I
felt like this was an easier way then manually switching back and forth. And
I felt like it was an accurate way of doing the A/B test. Of course, I've
been wrong before too. You definitly wouldn't want to key a transmitter with
this configuration, but I felt like it was a decent way to compare receivers
Mike - K9MI
-------Original Message-------
From: Scott Rosenfeld [N7JI]
Date: Tuesday, January 07, 2003 8:47:52 PM
To: tentec@contesting.com
Subject: [TenTec] P.S. on A/B testing
I didn't mean to poopoo A/B testing altogether. As I said, I've done
probably hundreds of hours of it, listening for rx and audio qualities,
MDS, ability to receive despite horrific conditions, etc.
When you get to a problem is trying to copy the same station on more than
one radio. If you can't have both receivers listening to the same signal
at the same time, you end up with possible variation in the signal being
received that you simple can't control. Yes, after flipping back and
forth a few dozen times, it will all even out statistically, but if the
two receivers are really, really close, and you want a definitive answer
as to which is better at hearing weak signals, a stable signal source is
truly the way to go.
(and nature is never truly predictable :)
--
Scott Rosenfeld ARS N7JI
541-684-9970 Eugene, OR Land o' much rain
If you find me on the air, I'm probably in my car
ham@w3eax.umd.edu http://w3eax.umd.edu/~ham
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
.
--- StripMime Report -- processed MIME parts ---
multipart/related
multipart/alternative
text/plain (text body -- kept)
text/html
image/gif
---
|