Good idea Bill!!! I've removed the foam rubber then remembered reading about
drilling a hole in the back of some had mics which some tmes also improves
the quality of the audio....did both mods and on another receive sounds ok,
now looking fer a ham friend familiar with the way it sounded before and
judge if the audio has improved!
Will let ya know if they judge it better or not....
tnx...73 /ed
From: "Bill Fulling" <w4njf@midflorida.com>
Hello Ed,
Open up the mike and remove the piece of foam rubber thats in front of the
mike element.
It looks sort of like an ear protector.Makes a whole lot of difference.
73 de W4NJF
Bill Fulling
From: "Eddy Avila" <k6sdw@hotmail.com>
> Howdy again,
>
> Using my Scout and the Ten Tec 701 hand mic sold for this rig I get
reports
> that my audio is muffled and way too much low's...I have two 701 mics
and
> both exhibit the same problem. However, using a Shure Bros desk mic with
a
> dyamic element the guys say my audio is much improved, but still not
great!
>
> Any help solving this audio problem mystery would be great appreciated!
>
> tnx....73 /ed
_________________________________________________________________
The new MSN 8: advanced junk mail protection and 2 months FREE*
http://join.msn.com/?page=features/junkmail
|