I built one up years ago, using a shaft encoder gleaned from a junk pile. Not
an aesthetic masterpiece, but it certainly works well.
Al, K2ZN
-----Original Message-----
From: John Clifford [mailto:johnclif@ix.netcom.com]
Sent: Wednesday, November 06, 2002 2:47 AM
To: tentec@contesting.com
Subject: [TenTec] RE: Ten-Tec 301 Remote tuning knob
Isn't this just a standard Omni V/VI optical encoder in a box?
How hard would it be to adapt a 302 to this (obviously the 302's keypad
would be unused)? Or, hmmm... a solution that would allow a 302 to be used,
complete w/keyboard, with an Omni VI? Hmmm... ! I've been meaning to
tackle a PIC project....
- jgc
John Clifford KD7KGX
Heathkit HW-9 WARC/HFT-9/HM-9
Elecraft K2 #1678 /KSB2/KIO2/KBT2/KAT2/KNB2/KAF2/KPA100
Ten-Tec Omni VI/Opt1
email: kd7kgx@arrl.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|