Because the Argosy uses the same frequency mixing scheme as the Tritons did,
the auxiliary Ten-Tec digital display unit ought to work with it.
But by the time you finish fiddling with that, you might be happier to buy a
Triton 544 or an Omni-C and then you'd have two rigs.
Mike N4NT
----- Original Message -----
From: <n4lq@iglou.com>
To: "Shawn Upton" <kb1ckt@yahoo.com>; <tentec@contesting.com>
Sent: Monday, October 07, 2002 12:46 PM
Subject: Re: [TenTec] Argosy Upgrades
The readout is available from Almost All Electronics at:
www.aade.com
I bought one for my Delta 580. Some customizing was needed and Neil at
AAE has been helpful. Be aware that you may experience some birdies from
these things. The non-readout rigs are quieter!
Steve N4LQ
-----Original Message-----
From: Shawn Upton <kb1ckt@yahoo.com>
To: tentec@contesting.com
To: <tentec@contesting.com>
Date: Mon, 7 Oct 2002 09:17:28 -0700 (PDT)
Subject: [TenTec] Argosy Upgrades
> I would like to add a freq readout to my Argosy. What
> are my options? I'd prefer to mount the unit inside
> the radio, but if it has to be external (or it simply
> is less work that way) then that's fine. Thanks.
>
> KB1CKT
> Shawn
|