I think I found the problem. After updating the Jup to 1.23, I left the
serial cable attached since I was playing around with the Pegasus
emulation mode. As soon as I disconnected the serial cable, the problem
went away.
Duffy
www.wb8nut.com
Bill Fulling wrote:
>Hello Duff,
>Got the same problem with my Jupe-have had several other rigs in the shack
>and every time I spoke to anyone at Dollyland,the stock answer was "you must
>have RF in ur shack".Got a darn near bulletproof ground system here
>and,no,other rigs do not exhibit ths problem.Basically,T/T rigs do not have
>good shielding and if you can live with this,thay are great.
>The problems with my Jupe are simalar to yours:
>1.On 20 mtrs,RF gets into my D104 mike-if I use a T/T 700 handheld,no
>problem.
>2.On 17 mtrs,RF gets into the T/T 700 but not into the D-104.
>3.When using the J-303 remote pod on 10 mtrs,the xmit freq will automaticlly
>start counting downward unless I "wriggle" the tuning knob on the
>remote-then it stops:this only occurs while in front panel operation.
>When in Peg emulation mode,the problem does not occur.
>Basically,the fundamental problem is piss poor shielding in the Jupe.
>73 de Bill W4NJF
>
>Bill Fulling
>w4njf@email.midflorida.com
>----- Original Message -----
>From: "J. Duffy Beischel" <duffyb01@fuse.net>
>To: <tentec@contesting.com>
>Sent: Saturday, September 21, 2002 10:56 AM
>Subject: [TenTec] Jupiter Issue
>
>
>
>
>>I installed 1.23 of the firmware and have a new, but very strange problem.
>>
>>I am using an LDG AT 11MP autotuner with the Jupiter. When on 15
>>meters, and this only happens on 15 meters, if I press the tune button
>>on the Jupiter, the rig immediately changes frequency to somewhere
>>between 20 and 22 Mhz. I have tried all other bands and everything
>>works fine on those bands. Anyone else experience this?
>>
>>Duffy
>>www.wb8nut.com
>>
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>
>
>
|