Hi Y'all,
Just been accepted to the Tentec club. Name is Malcolm call is F5VBU also
GM3UIN. Many moons ago after the failure of my trusty and much modified FT101B
decided to take a chance, bought a Corsair One from a friend in a non
transmittable mode. Replaced the driver transistors and she gave me wonderful
service, even now is still a good ham bands receiver.. Dynamic range second to
none...
2. Decided to go for a Corsair 2 also bought from a friend, very pleased with
the purchase because in the interim I was using a JRC JST 135 which I had
consistent bad keying reports on CW... The Corsair 2 is working fine with two
exceptions... a) on receive it does not got through the pass band of the signal
as I would analogically like eg with a bit of a warble (after all it is not
DDS) b) the 28 mhz dial readout gives a 1 instead of a 2 in the tens of
megahertz but transmits and receives as per normal. Tentec service maintain it
is a rf osc/mixer fault but using the JST135 to monitor on transmit is solid as
a rock..
3. Grateful any comments
73
Malcolm
NNNN
--- StripMime Report -- processed MIME parts ---
multipart/alternative
text/plain (text body -- kept)
text/html
---
|