Alan,
I'm glad you were able to resolve your sticking module problem. Please
note that it is NOT a good idea to use "steel wool" in or around
electronics. It leaves a fine residue that could cause you serious
problems in the future.
73,
Bill - K6WLM
ARDUJENSKI@aol.com wrote:
>
> Not exactly sure which was the cure but the contacts were all cleaned
> thoroughly with super fine steel wool and all joints resoldered. The module
> slides in nicely and locks right in properly. I noticed that the case screws
> also need to be JUST snug and too tight causes a distorted case.
>
> On the 80 and 40m modules I used a file to remove a little of the case spacer
> near the screw hole. This helped to slim down the case to make a noticeable
> difference in how it slides in.
>
> Hope this is of some benefit to others
>
> Alan KB7MBI in Woodinville, WA
> FISTS 5702 Proud member of ARRL
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|