Jim, my point exactly. You stated "All antennas put out more power over a
lossless ground." What makes for a lossless ground? Ideally, a solid
copper sheet that's 1/4 wavelength radius at the lowest frequency. Hence,
for vertical radiators, radials are required for improved radiation
efficiency thus lower radiation loss.
Bob K4TAX
----- Original Message -----
From: "Jim FitzSimons" <cherry@getnet.net>
To: "Ten Tec Reflector" <tentec@contesting.com>
Sent: Monday, September 02, 2002 12:54 PM
Subject: Re: [TenTec] Vertical Ant. Question / Suggestion
> Both the the GAP and Force 12 are center feed vertical dipoles and
> there is no way to attach a ground plane. They both work better over
> water or a very low loss ground. All antennas put out more power over a
> lossless ground. The antenna radition pattern is changed by the ground.
> The GAP Titan has a good pattern with the base at 7 feet above the
> ground.
> Jim W7ANF
>
> ----- Original Message -----
> From: "Ron Notarius WN3VAW" <wn3vaw@fyi.net>
> To: "Ten Tec Reflector" <tentec@contesting.com>
> Sent: Monday, September 02, 2002 10:14 AM
> Subject: Re: [TenTec] Vertical Ant. Question / Suggestion
>
>
> > While Jim has a very valid point, one must remember that while most
> > verticals are 1/4 verticals (with or without traps, tuning stubs, or
other
> > multi-band tuning methods), not all are.
> >
> > Theoretically, a half-wave vertical (be it a center fed vertical dipole
or
> > an end fed one) should not need (ie require) radials to work. However,
I
> > remember many, many moons ago bouncing this question off of Don W0DN,
the
> > inventor of the Butternut HF#V verticals (and at the time owner of
> > Butternut) -- it was regarding Cushcraft's claims on the then-new R3
> > antenna -- and his response was to the effect that any end-fed vertical,
> > even ones at 1/2 or full wavelengths, would perform better with radials
or
> > counterpoise at the base. While I don't recall all of his reasoning
(and
> I
> > think I still have the letter somewhere buried in the shack), I do
recall
> > that shortly after, I did some experimenting with a borrowed R3 and
found
> > this to be true.
> >
> > 73, ron wn3vaw
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|