Hi Ernie,
I have never updated a Pegasus just my Jupiter but it's almost
the same. It sounds like your computer is not talking to the
radio and likely it because of an incorrect port connection. Be
sure that the cable is connected to the port you're calling for.
Also be sure that the serial cable is good--try another. I had no
problems after I got the correct port connected. As a last resort
delete all the downloaded programs for updating from your
computer and reload everything again from
http://www.tentec.com/rfsquared
On the antenna tuner maybe the internal tuner doesn't have the
range to match your 80 meter antenna what are you using for an
antenna? If it's a resonate antenna on 80M does it work without
the tuner. Also try rebooting the Pegasus. Hold any button while
turning it on.
Let us know what you find.
73 Jim K4CGY
--- Ernest Mills <emills@nycap.rr.com> wrote:
> Hi Ya'll,
> and get an error message
> "...communication with Radio failed ...."
> I rebooted the computer, switched the rig off/on again and
> still get this message. Anybody got any ideas fer me? :)
>
> When I try and do an auto tune
> on 80, although it seems to go through it's thing, when I
> transmit the ALC led comes on at about 10w Forward, 4 watts
> rev, as measured on the CN-801 power/SWR meter. If I use the
> MFJ Versa tuner using the meter on it, I can tune normally and
> run the rig with about 50w with 1.5 reflected. Again any ideas
> would be really appreciated.
>
> Ernie WM2U
>
>
__________________________________________________
Do You Yahoo!?
Yahoo! Health - Feel better, live better
http://health.yahoo.com
|