Kent
Here is how I create these type of adapters.
http://www.qsl.net/k8zt/adapter.html
I fact I have on that goes fro 4 pin socket to ¼ phone plug to use my
new Ten-Tec mics on older Ten-Tec equipment and an 8 pin socket to 4 pin
plug to use my kenwood wired mic with ten-tec equipment.
Kent A. Badger wrote:
>Please check your shack for the following: ---A new front panel for an
>Argosy II ---T-T model 1126 T/R switch for Argosy II ---T-T
>model 234 Speech Processor ---Does anyone know where an
>in-line, 4 pin, chassis-type connector with some sort of enclosure can
>be found?......I'm trying to mate the standard T-T 4-pin hand mikes to
>some non T-T equipment and don't wish to butcher up the T-T mike
>connectors......Please email direct with cost including shipping........
>Many thanks for your time........73..........Kent, N3KB
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
--
|--------------------------|
Anthony A. Luscre
K8ZT
Stow, Ohio
|--------------------------|
Visit My Website at
http://www.qsl.net/k8zt
|--------------------------|
|