I'll second that motion. I've yet to find a car (domestic OR foriegn) that
doesn't have a loose fastener somewhere. I got my Centurion secondhand
from an estate, and it'd been transported halfway across the country by
non-hams. It had a few loose fasteners, which I went through and tightened
on my own personal inspection. They could've been that way from day one,
for all I know, but they've never come loose on me since.
I'll add note that Icom's IC-7xx series HF rigs from the early-mid '80's
were notorious for loose screws, and not because they weren't tightened
during assembly. The screws were not set up with lockwashers, and with
thermal expansion from the optional internal power supplies, they'd
eventually loosen every darned PC-board screw. Every time my IC-745 starts
sounding a little ragged on the RX or TX side, I just open up the covers
and go from one end to the other, and torque each screw, replace the
covers, and return to operating.
I'll note, however- the Omni VI and Centurion whomps daisies all over the
IC-745 and SB-220, loose screws, or no loose screws.
--... ...--
DK :-)
At 07:14 PM 06/25/2002 -0400, you wrote:
>Ah yes, but try sending your car back!
>
>Bill Ames
>KB1LG
>----- Original Message -----
>From: Steve M <wmoorejr@cox.net>
>To: tentec <tentec@contesting.com>
>Sent: Tuesday, June 25, 2002 2:15 PM
>Subject: Re: [TenTec] eham centurion 0 review
>
>
>> If your television or vcr had screws backing out, nuts and washers rolling
>> around loose, and buzzed whenever you used it would you think "cool it's
>> working"? How about these same things on your car--"cool I have something
>> to take it back to the dealer for"?
>>
>> The guy sounded reasonable to me. I don't blame him for sending it back.
>>
>> Steve
>> wd0ct
>>
>> ---- Original Message -----
>> From: "Rob Atkinson, K5UJ" <k5uj@hotmail.com>
>> To: <tentec@contesting.com>
>> Sent: Tuesday, June 25, 2002 12:43 PM
>> Subject: [TenTec] eham centurion 0 review
>>
>>
>> > someone has posted a centurion review on eham giving it a zero.
>complaint
>> > seems to stem from a few loose screws & transformer "buzz" on tx. Mine
>> > seems to buzz a little on keydown--my only thought when it was new was
>> > "Cool; it's working."
>> >
>> > Rob
>> > K5UJ
>> > k5uj@hotmail.com
>> >
>> > _________________________________________________________________
>> > MSN Photos is the easiest way to share and print your photos:
>> > http://photos.msn.com/support/worldwide.aspx
>> >
>> > _______________________________________________
>> > TenTec mailing list
>> > TenTec@contesting.com
>> > http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
73's from KW0D Dave in LeClaire, Iowa
|