[TenTec] OMNI V using RS-232

[dbp@conknet.com (David Perrin)]

I have not used the RS-232 port on the OMNI V with success. The
serial cable is wired as in the manual. Is a level converter
needed as with ICOM? Address? Port speed? Flow control? Any hints
and software ideas for the OMNI V would be appreciated. I am/was
expecting to use "YP log". Ideas?
73 de Dave K1OPQ here or at k1opq@arrl.net

--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com