TenTec
[Top] [All Lists]

[TenTec] Re: open wire line

To: <tentec@contesting.com>
Subject: [TenTec] Re: open wire line
From: SEWATKINS@dgs.state.va.us (Sherrill WATKINS)
Date: Mon, 22 Jan 2001 16:54:48 -0500
On hf, any balanced center fed antenna, i.e. zep, dipole or loop etc., operated 
with a high vswr should be fed with open wire line, where feasible.  This is 
because open wire line has extremely low loss and very high vswr 
characteristics.  Open wire line can be connected to coaxial cable quite 
easily, and remain balanced.  This is accomplished by using two parallel runs 
of coax of equal length.  Simply connect the shields together at each end.  One 
then has two shielded center parallel conductors that can be connected to the 
open wire line.  The coax can then be pulled through walls easier than the open 
wire type. (Of course for low power, TV type of ribbon line can be used with 
good success and can be easily pulled through walls.)  If one uses RG-11 the 
nominal impedance of the two parallel lines will be 150 ohms instead of 75.  
The larger the coax the better because the larger cable usually has lower 
losses and higher voltage ratings.  Also, this makes for a fairly good match to 
300, 450 or 600 ohm open wire line and the small mismatch is insigificant.  By 
using two parallel runs of coax in this manner, the peak voltage rating is 
doubled.  I have written about using this technique before, as well as several 
articles have appeared in QST recommending this technique to feed open wire 
line to a balanced antenna. Also, open wire line will not radiate unless one of 
two following conditions exists:  1.  The spacing of the conductors exceeds one 
percent of the wavelength,  and  2.  There is an inherent imbalance somewhere 
in the antenna system,  i.e. one side longer than the other that will cause the 
currents on the transmission line to be out of phase or if the open wire line 
is fed with unbalanced current.   As long as one is using a highly efficient 
transmission line and a very low loss antenna tuner (i.e. E.F. Johnson Matchbox 
or equivalent) then the presence of high vswr on the transmission line is not 
important as no sigificant losses will occur.  This has the very optimum 
advantage of allowing one to use one's 
results.   This technique has been clearly explained by Mr. Walter Maxwell 
(W2DU) in his series of about seven articles entitled " Another Look at 
Reflections"  that appeared in QST from about 1973 to 1976.  He later used the 
articles as a basis to publish a book by the same name.  The book was published 
by the ARRL for a brief period and is well worth reading. Unfortunaly, it is no 
longer available from ARRL.   Also, older issues of the ARRL Antenna book had 
chapters clearly explaining how to build a simple all hf band system using open 
wire line and link coupled antenna tuners.  Also,  I quote from Mr. Maxwell as 
stated in QST: " A LOW VSWR WILL KILL YOU !"  - 73's-  Corn -k4own


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>