Hi Everyone,
Has anyone with an older Omni VI had the opportunity to have the crystal
oven on the logic board replaced with the TXCO now used in current
production lots of the Omni VI+?
If yes, has it improved frequency stability of the rig?
My 5 year old Omni VI has developed some annoying frequency instability from
what I suspect is the 10 mhz crystal oven. New crystals and ceramic
trimmers in the BFO circuit have not improved the problem. Drift is out of
spec significantly even after 30 minute warm up.
Would welcome any comments.
73 de N1LQ-Dave
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|