Phil,
Those are the values the counter is initialized with for the various
bands. This means no frequency is getting to the counter at all.
You could have a mixer stage not running. The OMNI C is single
conversion. A different crystal and the PTO are mixed for each band to
produce the 9 MHz IF.
Carl Moreschi N4PY
cjm@qvssoftware.com
----- Original Message -----
From: "Phil Sikes" <psikes@whidbey.net>
To: <tentec@contesting.com>
Sent: Tuesday, January 02, 2001 2:57 PM
Subject: [TenTec] Omni C problem
>
> Hello to the group. My recently acquired Omni C has developed a
> problem I hope someone can help me with. When powered up the display
> reads 9.0000 on 20M and up. 30M reads 91.0000 and 40 and 80 read
> 10000. I know the 9.0000 is the oscilator freq. but any ideas on why
> the display is reading it? The rec. works FB, just don't know where I
> am!!
>
> 73 - Phil
> N7UX
>
> -- Phil Sikes, psikes@whidbey.net on 01/02/2001
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|