Dale,
I can read...I thought it might have had more of a reduction. I pulled the
schematics and can see that it is an identical input rather than a higher
level...
Sorry for asking...
Tom, K4NR
-----Original Message-----
From: Dale L Martin <kg5u@hal-pc.org>
To: Ten-Tec Reflector <Tentec@contesting.com>
To: <tentec@contesting.com>
Date: Thursday, July 13, 2000 7:45 PM
Subject: RE: [TenTec] AFSK with the Omni 6
>
>
>
>> Greetings,
>>
>> I'm getting ready to get my RTTY station back on the air. On my Kenwood
>> TS-850 I was able to use the AFSK connector on the rear of the
>> rig to accept
>> line-level output from my SB-32AWE. Is the audio input on the rear of
the
>> Omni 6 line-level or is it "microphone" level? If the latter,
>> I'll need to
>> make a circuit to reduce the line-level output of the PC...
>>
>> 73 de Tom, K4NR
>>
>
>What does your manual say?
>
>I opened my manual to page 3-3 and it said:
>
>The rear panel audio input and front panel mic jack are in parallel. When
>operating afsk, make sure the mike is not live. When operating SSB, make
>certain the afsk system is turned off or disconnected.
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|