TenTec
[Top] [All Lists]

[TenTec] external signal source

To: <tentec@contesting.com>
Subject: [TenTec] external signal source
From: Bill_Ames@hyperion.com (Bill_Ames@hyperion.com)
Date: Fri, 29 Oct 1999 10:53:30 -0400



I haven't looked at the circuit but to do so is relatively easy. You just
monitor the PTO frq and when it changes more then a set limit you change the
voltage applied to a diode (which is acting as a capacitor) to correct the frq.
If it drifts past the range of this circuit you just reset the voltage to
nominal and start again. This will cause a frq jump.

> How does the computer retune the PTO ?



--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>