Hi Clark--
I have an Omni-C with serial 546-4109. There is no letter following the
546.
73 de Mike N4NT@wireco.net
Johnson City, TN
----- Original Message -----
From: Clark Savage Turner <csturner@falcon.csc.calpoly.edu>
To: Ten-Tec Reflector <TenTec@contesting.com>
Sent: Saturday, October 23, 1999 10:27 PM
Subject: [TenTec] Info about OMNI-D series needed
>
> Hi All -
>
> I have had the OMNI-D series C, model 546C, some time ago.
> Liked it oK. About to buy another if I can ... a fellow
> has one that has the frequency counter on the front (OMNI-D
> not analog), but the model number is 546, apparently no
> letter after it. Does this mean it is neither a series
> B nor a series C? I suspect it is not a C, of course,
> but was there a version just plain OMNI-D and then a
> series B, and if so, was there a B after the model number,
> thus making this one a plain vanilla OMNI-D?
>
> After that question, does this mean that it has no options
> for crystal filters? The series C offered two optional filtr
> slots, and I am not sure about the series B. I believe
> the analog, first version OMNI-analog did not have any
> provisions for optional filters other than possibly an
> audio filter. I really liked the dual filtering of the
> OMNI-D series C. I recall the B had it but used different
> switches to engage the filters than does the C. If there
> was a previous version of the OMNI-D, what did it provide?
>
> I would really appreciate any information on this one. It
> is a gap in my Ten Tec knowledge.
>
> Clark
> WA3JPG
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|